This innovative product gets between buttons and squeezes into seams.Can you put my logo on name brand apparel? The EasyPress Mini was specially developed to make applying iron-on to tricky surfaces safe and easy. In that case, I recommend the Cricut EasyPress Mini paired with Cricut Heat Resistant Tape. While this technique worked perfectly for my impromptu project, if you want to add iron-on to hats or shoes on a regular basis, you might want to invest in some dedicated supplies. Heat presses get over 300 degrees F, but so long as you protect your hand, you can hold just about anything to the plate of your heat press, apply pressure, and transfer the design. The important thing is to keep your hand protected. You can use this technique to apply heat transfer vinyl to just about any awkward item. Easy peasy lemon squeezy, as my daughter would say! I used the towel to press it against the plate of my press again. I lined up the design and relied on the sticky carrier sheet to hold it in place while I pressed. Next, I wanted to add “I’m a real hoot!” to the bill of the hat. If you do not have a heat press, you can use a regular iron with a similar technique. I slightly rolled the design while heating it. I pressed the hat right to the plate of my heat press and pushed up on the towel to get enough pressure to transfer the design. Since I did not have any specialty tape to hold the design in place, I held one edge of the design while I pressed the other end. I put the hat on the towel and and lined up my design. I opted to roll it from both ends, but you can do whatever works best for you. Fold the towel in half once or twice length wise and then roll it up towards the middle. The type of towel does not really matter - I grabbed this beach towel because it was colorful (truth). I heated up my heat press and grabbed a towel. (For more tips and tricks for working with glitter heat transfer vinyl, check out my post, Glitter Heat Transfer Vinyl Made Easy.) Once the owl was cut, I used my weeder tool to remove the excess iron-on from around my cut design. I didn’t go over any seams with this project (just because the size of the owl fit within the seams), but if you did go over seams, glitter or flock heat transfer would hide the seam better than smooth iron-on HTV. Note: For hats, I recommend glitter iron-on or flocked heat transfer vinyl. Next, I mirrored the design and set the material to glitter iron-on heat transfer vinyl. I measured my hat and sized the owl to fit. When you open the file, you’ll see this cute little owl. This project highlights the owl design that is part of the 12 Exclusive Heat Transfer Vinyl Designs that I created for Craft-e-Corner. I also didn’t have time to buy special heat press tape - Hat Day was tomorrow and this project couldn’t wait! I winged it without anything other than the glitter heat transfer vinyl that I already had on hand and a hat we picked up on clearance. I don’t plan on making a lot of hats, so buying a special heat press just for hats was totally out of the question for me. No fancy attachments, no special tape… I didn’t have to pick up anything special for this project, but it turned out great. If you want to skip buying extra attachments or specialty equipment too, follow on!Īdding iron-on heat transfer vinyl to a hat is completely doable with a regular flat heat press or household iron, you just have to find a way to support your project so you can get enough pressure on the iron-on. I don’t make many hats, but wanted to create a custom one for Hat Day at school, without investing in anything more than iron-on heat transfer vinyl and the hat.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |